KNX universal dimming actuator 1-fold, 20-500VA 3901 REGHE

KNX universal dimming actuator 1-fold, 20-500VA 3901 REGHE – Jung – 4011377117006: KNX universal dimming actuator / speed control 1-fold 3901 REGHE bus system KNX, other bus systems without, version dimming actuator, mounting type REG, width in modular units 4, with bus coupling, local/manual operation, with LED display, number of outputs 1, output power 20 ... 500W, load type universal, Voltage 110 ... 230V, frequency 50 ... 60Hz, KNX universal dimming actuator / speed controller, 1-fold, REG, with electronic manual control, 1 x 500 W, ETS product family lighting, product type dimmer, switching and dimming of HV incandescent lamps as well HV LED, 230 V halogen lamps and LV halogen lamps with inductive transformers or Tronic transformers, status display of the outputs via LED, automatic or manual selection of the dimming principle suitable for the load, no-load protection against short circuits and overtemperature, message in the event of a short circuit, outputs can be operated manually , feedback of the switching state and the dimming value, configurable switch-on and dimming behavior, time dimmer: switch-on delay, switch-off delay and staircase light switch, light scene operation, memory Detect individual outputs manually or via the bus, operating hours counter, speed controller for speed control of single-phase motors such as e.g. B. Induction shaded-pole or universal motors, mounting on DIN rail according to DIN EN 60 715 in sub-distribution board, nominal voltage: AC 110 to 230 V ~, 50/60 Hz, power loss (maximum load of all outputs): maximum 4.5 W, type of contact: e , MOSFET, connection: screw terminals, 0.5 to 4 mm² (solid), 0.5 to 4 mm² (finely stranded without ferrule), 0.5 to 2.5 mm² (finely stranded with ferrule), motor loads: switching current: 2.3 A, lamp loads: connected load: 230 V per output, incandescent lamps: 20 to 500 W, HV halogen lamps: 20 to 500 W, Tronic transformers: 20 to 500 W, conventional transformers: 20 to 500 VA, ohmic-capacitive: 20 to 500 W, ohmic-inductive: 20 to 500 VA, capacitive-inductive: not permitted, connected load 110 V per output: incandescent lamps: 20 to 250 W, HV halogen lamps: 20 to 250 W, Tronic transformers: 20 to 250 W, conventional transformers: 20 to 250 VA, ohmic-capacitive: 20 to 250 W, ohmic-inductive: 20 to 250 VA, capacitive-inductive: not permitted, do not connect electronic lamps s, eg switchable or dimmable compact fluorescent lamps or LED lamps. Device can be damaged, ambient temperature: - 5 to + 45 °C, storage and transport temperature: - 25 to + 70 °C, width: 72 mm (4 TE), power failure longer than approx. 5 seconds leads to the dimming actuator being switched off. Depending on the parameter setting, the connected load is recalibrated after the mains returns.