Bus gateway RS485 - Multiple interface for bus system FGW14

Bus gateway RS485 - Multiple interface for bus system FGW14 – Eltako – 30014017 – 4010312313855: Bus gateway RS485 FGW14 bus system radio bus, other bus systems without, radio bidirectional, design multiple interfaces, mounting type REG, width in modular units 1, operating voltage 12V, protocol other, protection class (IP) IP20, multiple gateway. Bidirectional. Standby loss only 0.5 watts. Modular installation device for mounting on DIN rail. The gateway is only 1 TE wide, but can be used in several ways: for coupling up to three radio receiver modules, for direct connection to the PC via the RS232 interface, for connection to the bus components of the older 12 series or as a bus connector for two RS485 -Buses of the 14 series. Connection to the Eltako RS485 bus. Bus cross-wiring and power supply with jumper. The hold terminal is connected to the FAM14 or FTS14KS. Radio receiver modules are connected in parallel to the sub-bus terminals RSA2 and RSB2 and the power supply terminals GND and +12V. Up to 10 FTS14EM pushbutton input modules are connected in series to the RSA2 and RSB2 sub-bus terminals, if necessary in series with FEM radio receiver modules. The PC connection is made by connecting to the Tx and Rx terminals. Series 12 actuators are connected to sub-bus terminals RSA2 and RSB2. There is no hold connection here. A second Series 14 bus is fed in via terminals RSA2/RSB2. The BA operating mode rotary switch is set according to the operating instructions.