Analog input terminal 2-channel, XTR - Fieldbus analogue module 2 In / 0 Out 750-482

Analog input terminal 2-channel, XTR - Fieldbus analogue module 2 In / 0 Out 750-482 – WAGO – 4017332319522: Analog input terminal 2-channel, XTR 750-482 supply voltage at DC 24... 24V, voltage type of the supply voltage DC, input, voltage, resolution of the analog inputs 12-bit, number of analog inputs 2, number of analog outputs 0, number of HW interfaces Industrial Ethernet 0, number of PROFINET interfaces 0, number of HW interfaces serial RS-232 0, number of HW interfaces serial RS-422 0, number of HW interfaces serial RS-485 0, number of HW interfaces serial TTY 0 , number of parallel HW interfaces 0, number of wireless HW interfaces 0, number of USB HW interfaces 0, number of other HW interfaces 0, system components, degree of protection (IP) IP20, design of the electrical connection spring-loaded connection, fieldbus connection via separate bus coupler possible, DIN rail mounting possible, explosion protection category for gas without, explosion protection category for dust without, width 12mm, height 64mm, depth 100mm, the analog input terminal h at the task of supplying the measuring transducers located in the field and transmitting analogue measuring signals to the bus system in a galvanically isolated manner. The supply voltage of 24 V is fed in via the power contacts for the field. The shield connection is routed directly to the mounting rail. The overload protection switches the measuring input to the high-impedance state from a current of approx. 25 mA. The high-impedance state is automatically reset when returning to the normal measuring range. This terminal provides the power supply for 2-wire transmitters that do not have their own power supply. Up to 4 HART secondary variables (PV, SV, TV, QV) can be displayed in the cyclic process image of the coupler or controller per channel (configurable). For HART communication to connected intelligent HART field devices, the HART protocol can be displayed in the cyclic process image of the coupler or controller (configurable). FDT/DTM device drivers are available for some (programmable) couplers, with which HART tool routing to the connected HART device is possible.