Blister pack Switch - Radio receiver 868MHz BPS55 #30000037

Blister pack Switch - Radio receiver 868MHz BPS55 #30000037 – Eltako – 30000037 – 4010312317846: Blister pack switching BPS55 30000037 Suitable for pulse pushers, Suitable for switches, In the housing, Power supply 230 V AC, Push-button operation, Switching operation, Number of relays 1, Type of installation Other, Material plastic, Material quality thermoplastic, Halogen-free, Surface other, Design of the surface matt, other type of attachment, color blue, suitable for degree of protection (IP) IP20, radio frequency 868MHz, rolling code system, number of commands 32, blister pack switching with wireless pushbutton F2T55E and wireless actuator surge switching relay FSR61-230V. Smart home sensor and smart home actuator. F2T55E: Wireless pushbutton pure white glossy for individual installation 80x80x15mm or installation in the E-Design55 switch system. Generates the energy for radio telegrams itself when a button is pressed, therefore without a connecting cable and no standby loss. Wireless pushbuttons with a rocker can send two signals that can be evaluated: press the rocker up and press the rocker down. The mounting plate can be screwed onto a flat surface or glued to the wall, glass or furniture using the adhesive film provided. The sleeves in the box are used for screw fastening over a 55mm switch box. FSR61-230V: Wireless actuator impulse switching relay 1 NO contact, potential-free 10A/250V AC, incandescent lamps 2000 watts, off-delay with switch-off early warning and button permanent light can be switched on. Encrypted radio, bidirectional radio and repeater function can be activated. Standby loss only 0.8 watts. For flush mounting. 45mm long, 45mm wide, 33mm deep. Supply and control voltage locally 230V. If the supply voltage fails, the switching status is retained. When the supply voltage returns, it is switched off in a defined manner. After installation, wait for the brief automatic synchronization before the switched consumer is connected to the mains. In addition to the radio control input via an internal antenna, this radio actuator can also be controlled locally with a conventional control button that may be installed in front of it. A glow lamp current is not permitted.