Wind sensor SIWS

Wind sensor SIWS – Doepke – 09500206 – 4014712077539: Wind sensor SIWS mounting type surface-mounted, wind sensor function, run-on function, number of channels 0, time range 0min, number of universal dimming channels 0, number of dimming functions 0, power surge function, number of channels 0, shutter/sun protection control, number of channels 0, wind sensor 0 . .. 32m/s, number of channels 1, control voltage 1 0V, control voltage 2 0V, rated current 0A, rated voltage 0V, rated frequency 0Hz, degree of protection (IP) IP54, width in modular units 0, width 120mm, height 200mm, depth 120mm, The SI system (current-impulse system) is a control and automation technology for hard-wired installation. Due to the wide range of function modules and the logic through the wiring, it enables the implementation of a large number of control tasks. This includes the light and time-dependent switching of electrical consumers (e.g. lights, roller shutters, blinds), dimming functions for low-voltage and DALI lights or the protection of roller shutters and awnings from wind and rain. These can be supplemented with individual group and central commands as required. The SI system does not require any PC programming, so it can be installed conventionally. Since the wiring largely corresponds to the controls with relay or contactor circuits, the expenses for planning and commissioning are very low. Due to the consistent use of the control and supply voltage of 24 V DC and the strict separation between safety extra-low voltage and low-voltage side, the components are compact, cost-effective and immune to interference. In addition, control cables with a length of up to 100 m allow a simple connection of standard switch programs even in large buildings. The system is particularly suitable for lighting control. Among other things, remote dimmers, the DALI gateway and twilight sensors are available for this purpose. Sensors record physical, chemical, digital or analogue properties and convert them into electrical signals for further processing. The SIWS anemometer and the SIWR evaluation unit form a component that protects blinds, awnings and skylights alone or in the SI system. The wind strengths that trigger closing or opening can be selected. Properties: Wind monitor as a combination of anemometer SIWS and wind relay SIWR, adjustable sensitivity, make and break contact, power supply 24 V DC, type of installation: surface mounting, installation on the SIWH telescopic bracket is recommended, areas of application: the combination of wind sensor SIWS and wind relay SIWR is suitable due to the Detection of winds to control, among other things, external blinds, awnings. skylights.