Water detector for hazard detection SHT 217

Water detector for hazard detection SHT 217 – Schabus – 300217 – 4044764001688: Water detector for pump control SHT 217, type of water, mounting type other, display visual/acoustic, operating voltage 230V, height 121mm, width 57mm, depth 38mm, The water detector SHT 217 is a ready-to-plug pump control that switches on a connected water pump when a certain water height is reached and after a switches off again after the specified time, the run-on time of the pump is set from 0 to 100 seconds using a continuously variable adjustment wheel, an acoustic and visual warning signals the water level change. Extension sensor cable: If necessary, you can extend the sensor cable up to 50 m with a cable (2x 0.14 mm²). You must cut the existing sensor cable and reconnect it with clamps. Without acoustic alarm: The same device is available as a water detector SHT 218 (item no. 300218) without an acoustic alarm. Use with non-conductive liquids: For other liquids such as heating oil, diesel, vegetable oil, lubricating oils, etc., you need the device SHT 227 (item no. 300227) with a float switch. Use of water sensor in the pump sump (condensation water): Use the device SHT 227 (item no. 300227) with mini float switch if the water sensor is used for cyclic operation. Technical data: Operating voltage: 230 V AC/50-60 Hz, switching capacity: 3500 VA (2300 W)/16 A (10 A), power consumption: approx. 3 W, buzzer sound pressure: 80 dB (10 cm distance), follow-up time: Adjustable from 0 to 100 s, sensor cable length: extendable up to 50 m (with 2x 0.14 mm²), functional range: -15 °C/+40 °C, protection class: IP 20, cable length: 2.8 m 2x 0.14 mm², dimensions (HxWxD): 121x57x38 mm