Staircase light time switch - Staircase lighting timer 1min TLZ12D-plus

Staircase light time switch - Staircase lighting timer 1min TLZ12D-plus – Eltako – 23100800 – 4010312401712: Staircase timer switch TLZ12D-plus electronic function with multifunction, mounting type DIN rail, width in modular units 1, installation depth 58mm, number of contacts as NO contact 1, number of contacts as NC contact 0, number of contacts as changeover contact 0, control voltage 1 230 ... 230V , type of control voltage 1 AC, frequency of control voltage 1 50 ... 50Hz, control voltage 2 8 ... 230V, type of control voltage 2 AC/DC, rated switching current 16A, max. switching current (cos phi = 0.6) 4A, off-delay 1 ... 1min, button glow lamp current 50mA, switching type 3- and 4-wire circuit, switch-off pre-warning flickering, current surge function selectable, subsequent switching can be switched + permanent light + time extension, supply voltage 250 ... 250V, voltage type of the supply voltage AC, max. incandescent lamp load 2300W, max. fluorescent lamp load 1000VA , Max. Fluorescent lamp load (duo circuit) 1000VA, Max. Fluorescent lamp load (parallel compensated) 500VA, Digitally adjustable staircase light time switch with Auss switch pre-warning and button permanent light can be switched on. Standby loss only 0.7 watts. With ESL optimization and multifunction. The functions and times are entered according to the operating instructions using the MODE and SET buttons and shown digitally on the LC display. A key lock is possible. Contact switching in the zero crossing to protect the contacts and lamps. In particular, this extends the life of energy-saving lamps. The noiseless electronics do not bother the most sensitive ear - in contrast to many synchronous motors with mechanical gears. Due to the use of a bistable relay, there is no coil power loss and no heating as a result, even when switched on. After installation, wait for the brief automatic synchronization before the switched consumer is connected to the mains. Control supply and switching voltage 230V. Additionally with electrically isolated universal control voltage 8..230V UC. For 3- and 4-wire circuits, reconnectable, with attic lighting for 4-wire circuit. Automatic recognition of the switching type. Glow lamp current up to 50mA, depending on the ignition voltage of the glow lamps. Accurate time setting 1 to 99 minutes. Own permanent light button with the protruding SET button in the TLZ, ESV, ES and ER functions. With motion detector control input BM, which converts the input signal into a control pulse in the TLZ function.