Universal dimmer switch without N for R+L+C load. - Dimmer flush mounted 0...400VA EUD61NP-230V

Universal dimmer switch without N for R+L+C load. - Dimmer flush mounted 0...400VA EUD61NP-230V – Eltako – 61100830 – 4010312108062: Universal dimmer switch without N for R+L+C load. EUD61NP-230V Other composition, Touch operation type of operation, Universal load type, Light value memory, Can be used with button, Flush mounting type, Screw mounting type, Material plastic, Material quality thermoplastic, Halogen-free, Surface untreated, Surface finish matt, Color blue, Rated voltage 230 . .. 230V, control voltage 230 ... 230V, rated power 0 ... 400VA, connection type screw terminal, core cross section 4 ... 4mm², device width 45mm, device height 45mm, device depth 18mm, min. depth of the device box 18mm, universal dimmer switch 230V without N -Connection. Without N-connection, Power MOSFET up to 400W. Standby loss only 0.5 watts. With control inputs for light buttons and light switches. For flush mounting. 45mm long, 45mm wide, 18mm deep. Universal dimmer switch for R L and C loads up to 400W, depending on the ventilation conditions. Automatic recognition of the load type R+L or R+C. Not suitable for energy-saving lamps ESL and 230V LED lamps, please use EUD61NPL or the dimmer EUD61NPN with N connection. Control voltage 230V. Minimum load 40W. Switching at zero crossing with soft on and soft off to protect the lamp. The minimum brightness (fully dimmed) can be set with the % rotary switch. The dimming speed can be set with the dimming speed rotary switch. At the same time, the duration of Soft-On and Soft-Off is changed. Short control commands switch on/off, permanent control changes the brightness up to the maximum value. An interruption of the control changes the dimming direction. The set brightness level is saved when the device is switched off. In the event of a power failure, the switching position and the brightness level are saved and, if necessary, switched on when the supply voltage returns. Automatic electronic overload protection and over-temperature shutdown. In the event that light switches cannot be replaced by light buttons, there is a separate control input for light switches: if the closed switch is briefly opened again, it is dimmed until it is briefly opened again. A change in the dimming direction takes place automatically at the two vertices. In addition, the direction can be changed by briefly opening the switch twice. With children's room circuit (only when controlled with a button): When switching on by pressing the button for a longer period of time, after approx. 1 second it is switched on with the lowest brightness and, as long as the button is pressed, it is slowly dimmed up without changing the brightness level last saved. With snooze function (only when controlled with a button): A double pulse dims the lighting from the current dimming setting down to minimum brightness and then switches it off. The maximum dimming time of 60 minutes depends on the current dimming setting and the set minimum brightness and can be shortened accordingly. You can switch off at any time during the dimming process by briefly pressing the button. A long press during the dimming process dims up and ends the snooze mode. Without N connection, therefore suitable for mounting directly behind the light button or light switch, even if no N line is available. L loads (inductive loads, e.g. wound transformers) and C loads (capacitive loads, e.g. electronic transformers) must not be mixed. R loads (ohmic loads, eg 230V incandescent and halogen lamps) can be added as desired.