Wire retainer

If cables are routed through self-drilled holes, especially if they are made of metal, there is always a risk that burrs and sharp edges will damage the insulation or even the current-carrying wires of a line or cable. In addition, in the rarest of cases, the hole produced is identical to the cable diameter. This creates a gap that allows debris to either enter or allow a loose cable to rub against the edge of the hole and become damaged over time. This is where the cable sockets from the eibabo technology store come to the rescue. These are available in different diameters, are made of soft plastic and thus close self-made holes, but also the openings at the ends of installation and empty pipes. Holes corresponding to the cable diameter can be punched through the pre-embossings attached to the cable insertion sockets, with which a tight seal of the cable bushing is then guaranteed.